They are the only two power cables that plug into the motherboard. Note color does NOT matter of connector, THAT, would be considered a Power Supply diagram of the motherboard. Note that color does NOT matter of connector, 2) Uses one 4-pin ATX +12 Volt power cable, Motherboard installed in computer case, the whitish square 4-socket hole connector, to the Bottom/Left corner of the Processor socket is the 4-pin ATX +12 Volt power cable's motherboard connector. (Right side of motherboard) The Sundays Static And Silence Rar. Motherboard installed in computer case, the motherboard connector for the 24-pin ATX main power cable is to the Right of the Blue IDE (PATA) connector. Good luck and thanks for choosing FixYa!! Have a look at these pictures for an idea >Please post back with the results and any more advice if needed. On some boards there are no colours but the markings are the same, so a good close look. On the motherboard look for the front panel, it should be marked PWR and coloured green, also the plug that connects to it should be marked PWR_SW. Get a strong flashlight and a magnifying glass (if you have one). If you have any further information, I could make a better guess, but for now. Give it a shot, and see if the board is getting power - are any of the fans running? The thing is, make sure you have that power switch connector on the right jumper, and turned the right way (positive where it should be). Make sure those front panel wires are in the right place, too - especially the power switch and reset switch. If you're getting no response from the board at boot, make sure you have the CPU fully seated in its' slot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |